Easy how to hang guide
A roller, utility knife and spare blades, paint tray, spirit level/plummet (scissor and twine), pencil, soft sponge, spatula, a container with clean water, wallpaper brush, steel ruler, paintbrush and adhesive.
1. Before installation
A thoroughly prepared surface is crucial to the result. Therefore the wall should be dry, smooth, and well anchored. In our Wallpaper school, you can read more about how to prepare different surfaces.
Roll out your wallpaper on a clean table and cut off each strip on the scissor markings. Every other strip is upside down and needs to be flipped around to the right way. All strips have text on top, to ease the installation process and direction. Always use a non-woven adhesive
(paste), avoid so-called combination glue.
2. Use a spirit level
Create a plum line with your plummet (scissor + twine) or a spirit level. Draw guidelines on the surface for an easier installation
3. Cover the whole area with adhesive
Apply adhesive on the wall equal to approximately the width of 2-3 strips (90-135 cm). It’s important to cover the whole area with adhesive to avoid any bare spots. A spot without glue becomes an air bubble under the wallpaper. Carefully apply an even layer of adhesive, use a paintbrush where the roller can’t reach.
4. Watch out for creases!
Follow the instructions on the top and bottom of the strip. Look what is up and down, carefully wrap the strip in the middle, make sure to not create any creases. Have the pattern on the inside of the wrap when you attach it to the wall, this to avoid staining the front with adhesive. Attach the top of the strip at the right height and in the right position before you let go of the wrap and let it fall.
5. If it goes wrong start over!
Examine the strip at the top and bottom before you press it against the wall. Never try to twist the strip into the right position when in the wrong position. Instead, loosen the strip and start over. Apply more adhesive if the previous layer is dry. If paste accidentally would end up on the front of the wallpaper, do not rub. Instead, use a soft sponge with water to wipe the adhesive away. A dry sponge may chafe on the print and destroy the wallpaper.
6. Use a wallpaper spatula
Use the wallpaper spatula to even out the surface and get rid of glue and air bubbles under the wallpaper. Remember to keep your tools clean at all times by continuously wiping them off to get glue and other residues off. Use the wallpaper tool in a sweeping motion starting from the ceiling to the floor, and from the middle outwards.
7. Be meticulous!
Continue with the next strip and align the pattern. Make sure that the strips are tightly joint so no underlying surface is visible in between. The adhesive must be applied out to the edges so the strips attach properly.
8. Change the blade often
Cut off everything that doesn’t belong to the wallpaper itself. Feel free to use a steel ruler or putty shovel as support when doing this. Don’t forget to change the blade on the knife often, a dull blade can easily rip and break the wallpaper.
Now continue, strip by strip, until the wall is finished. Have in mind to avoid isolation of the room. If the weather allows, open up and let the room ventilate until the adhesive is dry